Investigation of solder beading phenomenon under surface-mounted electrolytic capacitors

Abstract

Purpose

The purpose of this paper is to study the solder beading phenomenon (referring to larger-sized solder balls) of surface-mounted electrolytic capacitors. Solder beading could induce failures by violating the minimal electrical clearance on the printed circuit board (PCB). In modern lead-free reflow soldering, especially in high-reliability industries, such as automotive, aeroplane and aerospace, detecting and preventing such defects is essential in reliable and cost-effective manufacturing.

Design/methodology/approach

The large size of the involved components may block the view of automatic optical inspection; therefore, X-ray inspection is necessary. To detect the failure mode, X-ray imaging, cross-section grinding, optical microscopy and Fourier transformed infrared spectroscopy were used. High-resolution noncontact profilometry and optical microscopy were used to analyse component designs. The surface mounting process steps were also analysed to reveal their dependence on the issue. Test methods were designed and performed to reveal the behaviour of the solder paste (SP) during the reflow soldering process and to emphasise the component design relevance.

Findings

It was found that the reduction of SP volume only reduces the failure rate but does not solve the problem. Results show that excessive component placement pressure could induce solder beading. Statistical analysis revealed that differences between distinct components had the highest effect on the solder beading rate. Design aspects of solder beading-prone components were identified and discussed as the primary source of the problem.

Practical implications

The findings can be applied in surface-mount technology production, where the total failure count and resulting failure costs could be reduced according to the findings.

Originality/value

This paper shows that component design aspects such as the low distance between the underside of the component and the PCB and blocked proper outgassing of volatile compounds of the SP can be root causes of solder beading under surface-mounted electrolytic capacitors.

Citation

Straubinger, D., Toth, A., Kerek, V., Czeczei, Z., Szabo, A. and Geczy, A. (2022), "Investigation of solder beading phenomenon under surface-mounted electrolytic capacitors", Soldering & Surface Mount Technology, Vol. 34 No. 4, pp. 203-211. https://doi.org/10.1108/SSMT-06-2021-0039