The effect of fiber orientation on wear behavior of glass fiber-epoxy filled with particles
Industrial Lubrication and Tribology
ISSN: 0036-8792
Article publication date: 17 August 2018
Issue publication date: 13 November 2018
Abstract
Purpose
The fiber orientation is considered one of the important parameters that have an effect on the characteristics of composites. This paper aims to investigate the effect of fiber orientation on the abrasive wear of the glass-epoxy (G-E) composites with different silicon carbide (SiC) filler weights (Wt.%).
Design/methodology/approach
The wear rate of glass fiber reinforced with angle-ply 0º, ±45º and 90º is discussed. The G-E composites with different weights of SiC filler at angle ±45º are considered. Hand lay-up technique was adopted for specimen preparation. The influence of effective parameters such as filler Wt. %, normal load, abrasive size and abrading distance on the wear rate was presented and discussed.
Findings
Experimental tests including pin on disk, micro-hardness and scanning electron microscope were carried out to investigate the composite characteristics.
Originality/value
The experimental results showed that the resistance wear was superior in case of ±45º fiber orientations. A validation of the experimental results using Taguchi approach to verify the optimal wear rate parameters was presented.
Keywords
Acknowledgements
This paper forms part of a special section “Advances in Engineering Tribology Technology (ICEATAT2016)”, guest edited by Jeng-Haur Horng.
Citation
Abdel-Magied, R.K., Aly, M.F. and Elkhouly, H.I. (2018), "The effect of fiber orientation on wear behavior of glass fiber-epoxy filled with particles", Industrial Lubrication and Tribology, Vol. 70 No. 8, pp. 1552-1559. https://doi.org/10.1108/ILT-09-2017-0277
Publisher
:Emerald Publishing Limited
Copyright © 2018, Emerald Publishing Limited