Maps of 3D parameters for worn surfaces of composites PA and glass beads sliding on steel

Abstract

Purpose

This paper aims to present the influence of glass bead concentration in a matrix of polyamide on wear and several three-dimensional (3D) parameters of the surface texture when the composite is sliding on steel in dry contact.

Design/methodology/approach

There were mold disks with the following concentrations in glass beads: 2.5, 5.0, 10, 20, 30 and 50 per cent. The mix of glass beads has diameters in the range of several microns to 50 microns. Tests were done on a pin-on-disk tribotester, in dry regime, for the following parameters: average pressure (1, 2 and 3 MPa) and sliding speed (0.5, 1.0 and 1.5 m/s). Zones of 500 × 500 μm were investigated from worn tracks generated on the composite disks, and the average values of several 3D texture parameters were analyzed.

Findings

The authors plotted maps indicating no correlation between the glass bead concentration and the parameters characterizing the surface quality (amplitude parameters and functional parameters). Composites with concentrations of 10[…]30 per cent glass beads generated worn surfaces with better quality as compared to composites with extreme concentrations: low (2.5 and 5 per cent) and high (50 per cent).

Practical implications

This set of parameters allows for evaluating the influence of regime parameters on the surface quality, by comparing the obtained values before and after sliding, and this evolution of roughness parameters could give recommendations for selecting the friction couple of materials for particular contacts that function with repeated starts and stops.

Originality/value

The results encourage the researchers to use a set of 3D texture parameters instead of “classical” two-dimensional parameters, the arithmetic mean deviation of the profile, Ra, because this set of parameters better evaluate the surface quality, especially for worn surfaces.

Citation

Pirvu, C., Maftei, L., Georgescu, C. and Deleanu, L. (2017), "Maps of 3D parameters for worn surfaces of composites PA and glass beads sliding on steel", Industrial Lubrication and Tribology, Vol. 69 No. 1, pp. 42-51. https://doi.org/10.1108/ILT-11-2015-0166