Study on high-temperature wear and mechanism of Al-Si/graphite composites prepared by the die-casting process

Abstract

Purpose

This paper aims to improve the tribological properties of aluminum alloys and reduce their wear rate.

Design/methodology/approach

Carbon is placed in the model at room temperature, pour 680°C of molten aluminum into the pressure chamber, and then pressed it into the mold containing carbon felt through a die casting machine, and waited for it to cool, which used an injection pressure of 52.8 MPa and held the same pressure for 15 s.

Findings

The result indicated that the mechanical properties of matrix and composite are similar, and the compressive strength of the composite is only 95% of the matrix alloy. However, the composite showed a low friction coefficient, the friction coefficient of Gr/Al composite is only 0.15, which just is two-third than that of the matrix alloy. Similarly, the wear rate of the composite is less than 4% of the matrix. In addition, the composite can avoid severe wear before 200°C, but the matrix alloy only 100°C.

Originality/value

This material has excellent friction properties and is able to maintain this excellent performance at high temperatures.

Peer review

The peer review history for this article is available at: https://publons.com/publon/10.1108/ILT-10-2019-0454/

Citation

Deng, Y., Pan, X., Zeng, G., Liu, J., Xiao, S. and Zhou, Z. (2020), "Study on high-temperature wear and mechanism of Al-Si/graphite composites prepared by the die-casting process", Industrial Lubrication and Tribology, Vol. 72 No. 10, pp. 1153-1158. https://doi.org/10.1108/ILT-10-2019-0454