Effects of different wheel wear positions on dynamic performance of metro vehicles

Abstract

Purpose

Metro wheels running on different lines can undergo wear at different positions. This paper aims to investigate the effects of wheel wear at two typical positions, i.e. wheel flange and tread, on the dynamic performance of metro vehicles and analyzes the differences, with an aim of providing theoretical support on wheel reprofiling for different metro lines.

Design/methodology/approach

Wheel profile data were measured on two actual metro lines, denoted A and B. It was observed that wheel wear on Lines A and B was concentrated on flanges and treads, respectively. A metro vehicle dynamics model was built using multibody dynamics software SIMPACK. Then it was applied to analyze the differences in effects of wheel wear at different positions on vehicle dynamic performance (VDP) for various speeds (50, 60 and 70 km/h) and line conditions (straight line, R1000m, R600m and R300m curves). Critical speed and vibration acceleration were used as indicators of VDP during linear motion (on straight track), while VDP during curvilinear motion (on curved track) was evaluated in terms of wheel/rail lateral force, wheel/rail vertical force, derailment coefficient and wheel unloading rate.

Findings

First, compared to wheel profile with tread wear, wheel profile with flange wear showed better performance during linear motion. When the distance traveled reached 8 × 104 and 14 × 104 km, the vehicle’s critical speed was 12.2 and 21.6% higher, respectively. The corresponding vertical and lateral vibration accelerations were 59.7 and 74.8% lower. Second, compared to wheel profile with flange wear, that with tread wear showed better performance during curvilinear motion, with smaller wheel/rail lateral force, derailment coefficient and wheel unloading rate. When the vehicle speed was 50, 60 and 70 km/h, the maximum difference in the three indicators between the two wheel profiles was 40.2, 44.7 and 23.1%, respectively. For R1000m, R600m and R300m curves, the corresponding maximum difference was 45.7, 69.0 and 44.4%, respectively.

Practical implications

The results of the study can provide a guidance and theoretical support on wheel reprofiling for different metro lines. On lines with large proportions of curved sections, metro vehicles are more prone to wheel flange wear and have poorer dynamic performance during curvilinear motion. Therefore, more attention should be paid to flange lubrication and maintenance for such lines. On lines with higher proportions of straight sections, metro vehicles are more prone to tread wear and have poorer performance on straight sections. So, tread maintenance and service requires more attention for such lines.

Originality/value

Existing research has focused primarily on the effects of wheel wear on VDP, but fails to consider the differences in the effects of wheel wear at different positions on VDP. In actual metro operation, the position of wheel wear can vary significantly between lines. Based on measured positions of wheel wear, this paper examines the differences in the effects of wheel wear at two typical positions, i.e. tread and flange, on VDP in detail.

Citation

Zhu, A., Yang, S., Yang, J., Long, D. and Li, X. (2023), "Effects of different wheel wear positions on dynamic performance of metro vehicles", Industrial Lubrication and Tribology, Vol. 75 No. 3, pp. 305-314. https://doi.org/10.1108/ILT-09-2022-0274