Yoann Eulalie, Elisabeth Fournier, Philippe Gilotte, David Holst, Shaun Johnson, Christian Navid Nayeri, Thomas Schütz and Dirk Wieser
This paper aims to present an experimental investigation of an active flow control solution mounted at rear of a sport utility vehicle (SUV) with the objective of drag reduction…
Abstract
Purpose
This paper aims to present an experimental investigation of an active flow control solution mounted at rear of a sport utility vehicle (SUV) with the objective of drag reduction, thanks to a selection of flow control parameters leading to a pressure increase on the tailgate.
Design/methodology/approach
A flow control design of experiments was conducted with a pulsed jet system mounted on the top and sides of the rear window of the vehicle. The wall pressure, instantaneous velocity and drag were measured with this prototype in a wind tunnel. A dynamic modal decomposition (DMD) analysis of the pressure enables to describe the pressure fluctuations. Fluid dynamic computations show relation between pressure and velocity fields.
Findings
Measurements with this prototype in the wind tunnel revealed small improvements in drag for the best flow control configurations. This small benefit is because of the core of the upper span wise vortex further away from the rear window than the lower span wise vortex. These small improvements in drag were confirmed with pressure measurements on the rear window and tailgate. The DMD analysis of the surface pressure showed a low frequency pendulum oscillation on the lower area of the tailgate, linked with low velocity frequencies in the shear layers near the tailgate.
Originality/value
Experimental and numerical results show interest to increase pressure at bottom of the rear end of this SUV prototype. The dynamic description of the wall pressure shows importance of flow control solutions reducing pressure fluctuations at low frequencies in the lower area of the tailgate.
Details
Keywords
Stephie Edwige, Yoann Eulalie, Philippe Gilotte and Iraj Mortazavi
The purpose of this paper is to present numerical investigations of the flow dynamic characteristics of a 47° Ahmed Body to identify wake flow control strategy leading to drag…
Abstract
Purpose
The purpose of this paper is to present numerical investigations of the flow dynamic characteristics of a 47° Ahmed Body to identify wake flow control strategy leading to drag coefficient reduction, which could be tested later on sport utility vehicles.
Design/methodology/approach
This study begins with a mean flow topology description owing to dynamic and spectral analysis of the aerodynamic tensor. Then, the sparse promoting dynamic modal decomposition method is discussed and compared to other modal approaches. This method is then applied on the wall and wake pressure to determine frequencies of the highest energy pressure modes and their transfers to other frequency modes. This analysis is then used to design appropriated feedback flow control strategies.
Findings
This dynamic modal decomposition highlights a reduced number of modes at low frequency which drive the flow dynamics. The authors especially notice that the pressure mode at a Strouhal number of 0.22, based on the width between feet, induces aerodynamic losses close to the rear end. Strategy of the proposed control loop enables to dampen the energy of this mode, but it has been transferred to lower frequency mode outside of the selected region of interest.
Originality/value
This analysis and methodology of feedback control shows potential drag reduction with appropriated modal energy transfer management.