Search results

Cold-formed steel (CFS) sections are a popular choice for constructing medium and low-rise structures that are engineered to support relatively light loads. An important characteristic of CFS sections is that they are produced without the use of heat during manufacturing. Consequently, it becomes essential to gain a comprehensive understanding in the behavior of CFS sections when exposed to fire or elevated temperatures.

In this study, sections of 1.5 m length and 2 mm thickness were taken and analyzed to find its flexural behavior after heating them for 60 and 90 min. There were two modes of cooling phase which was considered to reach ambient temperature, i.e. air or water respectively. Performance of each sections (C, C with inclined flanges, sigma and Zed) were examined and evaluated at different conditions. Effects of different profiles and lips in the profiles on flexural behavior of CFS sections were investigated fully analytically.

The variation in stiffness among the sections with different lipped profiles was noted between 20.36 and 33.26%, for 60 min water cooling case. For the sections with unlipped profiles, it was between 23.56 and 28.60%. Influence of lip and section profile on reduction in stiffness is marginal. The average reduction in load capacity of sections for 60 min specimens cooled by water was found to be 43.42%. An increase in deflection is observed for the sections in the range of 25–37.23% for 60 min case. This is the critical temperature responsible for reduction in yield strength of material as it substantially increases the material safety margin to be considered for the design. Sections with Zed profile have shown better performance among other types, in terms of its load carrying capacity.

This paper deals with the flexural behavior of Galvanized (GI) based CFS unsymmetric sections at elevated temperature and cooled down to ambient temperature with air or water.

The capability of steel columns to support their design loads is highly affected by the time of exposure and temperature magnitude, which causes deterioration of mechanical properties of steel under fire conditions. It is known that structural steel loses strength and stiffness as temperature increases, particularly above 400 °C. The duration of time in which steel is exposed to high temperatures also has an impact on how much strength it loses. The time-dependent response of steel is critical when estimating load carrying capacity of steel columns exposed to fire. Thus, investigating the structural response of cold-formed steel (CFS) columns is gaining more interest due to the nature of such structural elements.

In this study, experiments were conducted on two CFS configurations: back-to-back (B-B) channel and toe-to-toe (T-T) channel sections. All CFS column specimens were exposed to different temperatures following the standard fire curve and cooled by air or water. A total of 14 tests were conducted to evaluate the capacity of the CFS sections. The axial resistance and yield deformation were noted for both section types at elevated temperatures. The CFS column sections were modelled to simulate the section's behaviour under various temperature exposures using the general-purpose finite element (FE) program ABAQUS. The results from FE modelling agreed well with the experimental results. Ultimate load of experiment and finite element model (FEM) are compared with each other. The difference in percentage and ratio between both are presented.

The results showed that B-B configuration showed better performance for all the investigated parameters than T-T sections. A noticeable loss in the ultimate strength of 34.5 and 65.6% was observed at 90 min (986℃) for B-B specimens cooled using air and water, respectively. However, the reduction was 29.9 and 46% in the T-T configuration, respectively.

This research paper focusses on assessing the buckling strength of heated CFS sections to analyse the mode of failure of CFS sections with B-B and T-T design configurations under the effect of elevated temperature.