Search results

This study aims to develop a new design for the fluid-safety valve to make it more environmentally friendly.

Computational fluid dynamics is carried out to analyse the behaviour of flow in both traditional and new safety valves.

The possibility of failure in the new design under the maximum allowable working pressure is analysed using finite element analysis.

Investigating a new low-fluid pressure safety valve design.

Using the computational fluid dynamics (CFD) technique, this paper aims to investigate the influence of key parameters such as throat diameter; the suction ratio on the flow field behaviors such as Mach number; pressure; and temperature.

To investigate the effect of throat diameter, it is simulated for 4, 6, 8 and 10 mm as throat diameters. The governing equations have been solved by standard code of Fluent Software together with a compressible 2 D symmetric and turbulence model with the standard k–ε model. First, the influence of the throat diameter is investigated by keeping the inlet mass flow constant.

The results show that a place of shock wave creation is changed by changing the throat diameter. The obtained results illustrate that the maximum amount of Mach number is dependent on the throat diameter. It is obtained from the results that for smaller throats higher Mach numbers can be obtained. Therefore, for mixing purposes smaller throats and for exhausting bigger throats seems to be appropriate.

The obtained numerical results are compared to the existing experimental ones which show good agreement.

This study aims to simulate Hunter turbine in Computer Forensic Examiner (CFX) environment dynamically. For this purpose, the turbine is designed in desired dimensions and simulated in ANSYS software under a specific fluid flow rate. The obtained values were then compared with previous studies for different values of angles (θ and α). The amount of validation error were obtained.

In this research, at first, the study of fluid flow and then the examination of that in the tidal turbine and identifying the turbines used for tidal energy extraction are performed. For this purpose, the equations governing flow and turbine are thoroughly investigated, and the computational fluid dynamic simulation is done after numerical modeling of Hunter turbine in a CFX environment.

The failure results showed; 11.25% for the blades to fully open, 2.5% for blades to start, and 2.2% for blades to close completely. Also, results obtained from three flow coefficients, 0.36, 0.44 and 0.46, are validated by experimental data that were in high-grade agreement, and the failure value coefficients of (0.44 and 0.46) equal (0.013 and 0.014), respectively.

In this research, at first, the geometry of the Hunter turbine is discussed. Then, the model of the turbine is designed with SolidWorks software. An essential feature of SolidWorks software, which was sorely needed in this project, is the possibility of mechanical clamping of the blades. The validation is performed by comparing the results with previous studies to show the simulation accuracy. This research’s overall objective is the dynamical simulation of Hunter turbine with the CFX. The turbine was then designed to desired dimensions and simulated in the ANSYS software at a specified fluid flow rate and verified, which had not been done so far.