Search results

Increasing heat transfer rate in spiral heat exchangers is possible by using conventional methods such as increasing number of fluid passes and counter flowing. In addition, newer ideas such as using pillows as baffles in the path of cold and hot fluids and using nanofluids can increase heat transfer rate. The purpose of this study is to simulate turbulent flow and heat transfer of two-phase water-silver nanofluid with 0-6 Vol.% nanoparticle concentration in a 180° path of spiral heat exchanger with elliptic pillows.

In this simulation, the finite volume method and two-phase mixture model are used. The walls are subjected to constant heat flux of q″ = 150,000 Wm⁻². The inlet fluid enters curves path of spiral heat exchanger with uniform temperature T_in = 300 K. After flowing past the pillows and traversing the curved route, the working fluid exchanges heat with hot walls and then exits from the section. In this study, the effect of radiation is disregarded because of low temperature range. Also, temperature jump and velocity slipping are disregarded. The effects of thermophoresis and turbulent diffusion on nanofluid heat transfer are disregarded. By using finite volume method and two-phase mixture model, simulations are performed.

The results show that the flow and heat transfer characteristics are dependent on the height of pillows, nanoparticle concentration and Reynolds number. Increasing Reynolds number, nanoparticle concentration and pillow height causes an increase in Nusselt number, pressure drop and pumping power.

Turbulent flow and heat transfer of two-phase water-silver nanofluid of 0-6 per cent volume fraction in a 180° path of spiral heat exchanger with elliptic pillows is simulated.

This is a 3D numerical study of convective heat transfer through a micro concentric annulus governing non-uniform heat flux boundary conditions employing water-Al₂O₃ nanofluid. The nanofluid is modeled using two-phase mixture model, as it has a good agreement to experimental results.

Half of the inner pipe surface area of the annulus section of a double pipe heat exchanger is exposed to a constant heat flux which two models are considered to divide the exposing surface area to smaller ones considering the fact that in all cases half of the inner pipe surface area has to be exposed to the heat flux: in model (A), the exposing surface area is divided radially to two parts (A1), four parts (A2) and eight parts (A3) by covering the whole length of the annulus and in model (B) the exposing surface area is divided axially to two parts (B1), four parts (B2) and eight parts (B3) by covering half of the annulus radially.

The results reveal that model (B) leads to higher Nusselt numbers compared to model (A); however, at Reynolds number 10, model (A3) exceeds model (B3). The average Nusselt number is increased up to 142 and 83 per cent at models (A3) with Reynolds number 10 and model (B3) with Reynolds number 1000, respectively.

This paper is a two-phase investigation of water-Al₂O₃ nanofluid in a micro concentric annulus under non-uniform heat flux boundary conditions.