Olli Nousiainen, Tero Kangasvieri, Kari Rönkä, Risto Rautioaho and Jouko Vähäkangas
This paper aims to investigate the metallurgical reactions between two commercial AgPt thick films used as a solder land on a low temperature co‐fired ceramic (LTCC) module and…
Abstract
Purpose
This paper aims to investigate the metallurgical reactions between two commercial AgPt thick films used as a solder land on a low temperature co‐fired ceramic (LTCC) module and solder materials (SnAgCu, SnInAgCu, and SnPbAg) in typical reflow conditions and to clarify the effect of excessive intermetallic compound (IMC) formation on the reliability of LTCC/printed wiring boards (PWB) assemblies.
Design/methodology/approach
Metallurgical reactions between liquid solders and AgPt metallizations of LTCC modules were investigated by increasing the number of reflow cycles with different peak temperatures. The microstructures of AgPt metallization/solder interfaces were analyzed using SEM/EDS investigation. In addition, a test LTCC module/PWB assembly with an excess IMC layer within the joints was fabricated and exposed to a temperature cycling test in a −40 to 125°C temperature range. The characteristic lifetime of the test assembly was determined using DC resistance measurements. The failure mechanism of the test assembly was verified using scanning acoustic microscopy and SEM investigation.
Findings
The results showed that the higher peak reflow temperature of common lead‐free solders had a significant effect on the consumption of the original AgPt metallization of LTCC modules. The results also suggested that the excess porosity of the metallization accelerated the degradation of the metallization layer. Finally, the impact of these adverse metallurgical effects on the actual failure mechanism in an LTCC/PWB assembly was demonstrated.
Originality/value
This paper proves how essential it is to know the actual LTCC metallization/solder interactions that occur during reflow soldering and to recognize their effect on solder joint reliability in LTCC module/PWB assemblies. Moreover, the adverse effect of using lead‐free solders on the degradation of Ag‐based metallizations and, consequently, on board level reliability is demonstrated. Finally, practical guidelines for selecting materials for second‐level solder interconnections of LTCC module are given.
Details
Keywords
Kari Kulojärvi, Vesa Vuorinen and Jorma Kivilahti
The dissolution processes and subsequent intermetallic reactions between high tin solder bump alloys and Cu‐ or Ni‐based UBM‐metallisations were investigated both theoretically…
Abstract
The dissolution processes and subsequent intermetallic reactions between high tin solder bump alloys and Cu‐ or Ni‐based UBM‐metallisations were investigated both theoretically and experimentally. The results showed that when the Cu UBM layer is used together with eutectic or higher Sn‐based solder alloys the dissolution of Cu and the rate of the Cu6Sn5 formation is too high for reliable interconnections. On the contrary, Ni provides feasible solution for UBM/high tin solder applications. Although there is strong chemical interaction between nickel and high Sn solder bump alloys, the dissolution and subsequent Ni3Sn4 layer growth rates are very low. Thus, a thin Ni layer can sustain interactions with high Sn liquid as well as solid solders during high temperature use. On the basis of the results obtained flip chip bonding with Ni‐based UBM structures provides a viable interconnection solution for reliable fine‐pitch applications.