Search results

The purpose of this paper is to investigate the density, surface quality, microstructure and mechanical properties of the components of the selective laser melting (SLM) parts made at different building orientations. SLM is an additive manufacturing technique for three-dimensional parts. The process parameters are known to affect the properties of the eventual part. In this study, process parameters were investigated in the building of 316L structures at a variety of building orientations and for which the fracture toughness was measured.

Hardness and tensile tests were carried out to evaluate the effect of consolidation on the mechanical performance of specimens. Optical and electron microscopy were used to characterise the microstructure of the SLM specimens and their effects on properties relating to fracture and the mechanics. It was found that the density of built samples is 96 per cent, and the hardness is similar in comparison to conventional material.

The highest fracture toughness value was found to be 176 MPa m^(1/2) in the oz. building direction, and the lowest value was 145 MPa m^(1/2) in the z building direction. This was due to pores and some cracks at the edge, which are slightly lower in comparison to a conventional product. The build direction does have an effect on the microstructure of parts, which subsequently has an effect upon their mechanical properties and surface quality. Dendritic grain structures were found in oz. samples due to the high temperature gradient, fast cooling rate and reduced porosity. The tensile properties of such parts were found to be better than those made from conventional material.

The relationship between the process parameters, microstructure, surface quality and toughness has not previously been reported.

The purpose of this paper is to study new process parameters which were selected to achieve the full density of Ti-6Al-4V samples in different building orientations and investigate fracture toughness property and its relation to the microstructure, an area which has not previously been reported in full detail and which may offer information to a designer. Direct metal laser sintering (DMLS) is an additive manufacturing technique that directly manufactures three-dimensional parts, layer-by-layer, to scan and melt metal powders for aerospace applications.

Hardness and tensile tests were carried out to evaluate the effect of consolidation on the mechanical performance of specimens made at three different building directions. Optical and electron microscopy were used to characterise the microstructure of the DMLS specimens and their effects on the fractures and mechanical properties.

It was found that the built samples have an excellent density at 4.5 g/cm, and the sample surfaces parallel to the building direction are rougher than the perpendicular surfaces. The fracture toughness result was higher than that of the cast material for the same alloy and higher than the Ti-6Al-4V parts fabricated by electron beam melting. This results in the superior mechanical properties of DMLS, while slightly lower in the zy direction owing to cracks, porosity and surface finish.

The tensile strength was found to be higher than the wrought material, and the samples exhibited brittle fractures owing to the martensitic phase, which is caused by a high temperature gradient, and the mechanical properties change with the change in the microstructures at different building directions.

This paper contains original research.