Search results

The purpose of this paper is to evaluate the effect of different drying methods on quality attributes of beetroot slices.

Three drying methods (sun, oven and freeze-drying) were applied to dry fresh slices of beetroot cultivar (Beta vulgaris). The chemical composition, minerals, nitrate, betalains, total phenolic, total flavonoid and color were measured for fresh and dried slices.

The chemical composition, minerals, nitrate, bioactive compounds and color were measured for fresh and dried slices. Regardless of the drying method, the results showed that the chemical composition, total energy, minerals and nitrate of the dried slices were significantly (p=0.05) increased compared to that of fresh slices. Sun and oven drying of the slices significantly (p=0.05) reduced total betalain and betacynin. However, betaxanthin was significantly (p=0.05) increased. Total phenolics content of fresh beetroot was significantly (p=0.05) increased after sun and oven drying but total flavonoids were decreased. The 2,2,-diphenyl-2-picryl-hydrazyl (DPPH) of fresh beetroot was increased significantly (p=0.05) after sun and oven drying. The measurement of the color of the powder showed that there is a decrease in lightness (L) depending on the drying method applied. A maximum reduction in lightness was observed in powder of sun-dried slices. The color of the powder obtained from freeze-dried slices was stable compared to other drying methods.

Beetroot is a rich source of nutrients but with short shelf life. Dried beetroot has more keeping quality than the fresh one.

The study uses beetroot as a rich source of nutrients as well as natural antioxidant source. Betalain compounds are preserved in beetroot and a high source of phenolics and flavonoids. Flavonoids are a group of phenolic products of plant metabolism with high antioxidant properties to protect against diseases without side effects.

This paper introduces a systems‐based framework to facilitate structured analysis of complex issues. The framework was created out of a management development effort with the primary emphasis on development of systems problem‐solving skills through analysis of complex operational issues. Drawing from systems science, the strength of the approach rests inthe holistic analysis of structure, relationships, and emergent dynamics of problematic situations. The fundamental systems principles underpinning the approach are developed to provide an essential “systems background” as a foundation for the framework. The utility of the framework is discussed with respect toresults from an application in an organizational setting. The paper concludes with a discussion of the implications and limitations of the framework for development of systemic thinking and complex problem analysis.

Electronics exhibitions are the same the world over, very tiring affairs. If your stand is busy, time flies; if not, the strain is more noticeable.

Examines the process of implementing a TQM programme and its management. Suggests that although managers recognize a need for change they do not appreciate the amount of change needed in their own behaviour and actions. Proposes that future management philosophy should be based on the bonding between management and workers. Goes on to investigate the importance of this, concluding that management should recognize that their workers are their major and most important resource.

This study aims to present the climate change effect on soil moisture regimes in Mexico in a global 1.5°C warming scenario.

The soil moisture regimes were determined using the Newhall simulation model with the database of mean monthly precipitation and temperature at a scale of 1: 250,000 for the current scenario and with the climate change scenarios associated with a mean global temperature increase of 1.5°C, considering two Representative Concentration Pathways, 4.5 and 8.5 W/m² and three general models of atmospheric circulation, namely, GFDL, HADGEM and MPI. The different vegetation types of the country were related to the soil moisture regimes for current conditions and for climate change.

According to the HADGEM and MPI models, almost the entire country is predicted to undergo a considerable increase in soil moisture deficit, and part of the areas of each moisture regime will shift to the next drier regime. The GFDL model also predicts this trend but at smaller proportions.

The changes in soil moisture at the regional scale that reveal the impacts of climate change and indicate where these changes will occur are important elements of the knowledge concerning the vulnerability of soils to climate change. New cartography is available in Mexico.

The current focus on air tight construction to minimise energy use in homes in the UK requires analysis of the behaviour of the occupants. The purpose of this paper is to review current literature and explore the methods used to dry clothes, to assess current standards and recommendation for the drying of laundry in new homes and the issues arising with increased moisture within the building envelope where there may be inadequate ventilation caused by impermeable design.

Literature is reviewed on new housing in the UK and as part of a wider study of behaviour questionnaires were delivered to occupants of a recently completed housing estate in the UK to ask the questions with regard to their laundry practice.

There are inherent problems in drying laundry in new air tight homes. This case study identifies 95 per cent of residents on a new estate own a tumble dryer and use either this high energy method for clothes drying or hang clothes internally within the property leading to higher energy use or potential mould growth.

Further research is required into how drying laundry impacts on internal air quality in new homes designed to be energy efficient.

The design of new houses needs to be considered to provide a shift in people’s behaviour with regard to low energy clothes drying.

Policy and regulation need to be changed urgently to ensure new homes are fit for purpose with regards to laundry drying.

Other research has focussed on tenants in social housing in properties of mixed ages. This is the first study which focusses specifically on new energy efficient housing for owner occupiers.

In the Court of Appeal last summer, when Van Den Berghs and Jurgens Limited (belonging to the Unilever giant organization) sought a reversal of the decision of the trial judge that their television advertisements of Stork margarine did not contravene Reg. 9, Margarine Regulations, 1967—an action which their Lordships described as fierce but friendly—there were some piercing criticisms by the Court on the phrasing of the Regulations, which was described as “ridiculous”, “illogical” and as “absurdities”. They also remarked upon the fact that from 1971 to 1975, after the Regulations became operative, and seven years from the date they were made, no complaint from enforcement authorities and officers or the organizations normally consulted during the making of such regulations were made, until the Butter Information Council, protecting the interests of the dairy trade and dairy producers, suggested the long‐standing advertisements of Reg. 9. An example of how the interests of descriptions and uses of the word “butter” infringements of Reg. 9. An example af how the interests of enforcement, consumer protection, &c, are not identical with trade interests, who see in legislation, accepted by the first, as injuring sections of the trade. (There is no evidence that the Butter Information Council was one of the organizations consulted by the MAFF before making the Regulations.) The Independant Broadcasting Authority on receiving the Council's complaint and obtaining legal advice, banned plaintiffs' advertisements and suggested they seek a declaration that the said advertisements did not infringe the Regulations. This they did and were refused such a declaration by the trial judge in the Chancery Division, whereupon they went to the Court of Appeal, and it was here, in the course of a very thorough and searching examination of the question and, in particular, the Margarine Regulations, that His Appellate Lordship made use of the critical phrases we have quoted.

The complex cellular structure and chemical nature of fruit and vegetable tissues retard evaporation so that under no conditions of temperature and humidity does the rate of evaporation from them equal that from a free water surface. When conditions are such that surface evaporation from the tissues exceeds the rate of moisture diffusion to the surface, the surface becomes dry and hard and seals in the moisture. This condition, known as case‐hardening, is overcome by reducing the temperature of the air or by increasing the humidity. The maximum rate of drying, then, is attained by using the highest temperature which will not injure the product, the humidity being sufficient to prevent case‐hardening. In general practice the temperature of the air entering the drying chamber should not exceed 160° to 170° F. The humidity at the air‐outlet end of the drier should not greatly exceed 65 per cent. In driers employing recirculation the conditions of temperature and humidity may be largely controlled by varying the recirculation. The velocities of air flow which produce the most efficient results in the drying chamber depend upon several conditions. In general the rate of drying increases with the velocity of air movement. Low air velocities tend to bring about slow and uneven drying. Exceedingly high velocities may not be used profitably because a point is app ched at which the materials will be blown from the trays or at which the increased speed of drying will not offset the cost of operating a larger fan. Velocities of 600 to 800 feet per minute through the drying chamber are satisfactory in tunnel driers; lower velocities are permissible in compartment driers. The most practical means of removing moisture from the air, and at the same time conserving heat, is through the steady discharge of a portion of the air leaving the drying chamber. The rest dries efficiently when mixed with fresh air from the outside and reheated. All forced‐draught driers, therefore, should be provided with recirculation ducts connecting the air‐outlet end of the drying chamber with the heaters and with dampers controlling the air discharged, recirculated, and drawn from the outside. Dehydrated fruits and vegetables should have a uniform moisture content low enough to inhibit undesirable microbic and chemical changes within the food, and they should be free from any part of the life cycle of moths or other insects. The moisture content of dehydrated foods directly controls deterioration within the food, and the protection afforded by sulphuring or blanching will not prevent insufficiently dried products from soon becoming unfit for use. Dehydrated products having a low moisture content are not readily attacked by insects. In the long run the additional protection afforded by a low moisture content will more than make up to the producer the loss resulting from the longer drying time and greater weight shrinkage involved. To assure best keeping qualities the moisture content of fruits containing much sugar should not exceed 15 to 20 per cent., while that of other fruits and vegetables should not exceed 5 to 10 per cent., the preference in both cases being for the lower percentage. The texture, or feel, of products is a guide in determining when the proper stage of dryness has been reached. At a given moisture content products usually feel softer when hot than after they have been cooled, and often they feel softer after standing until the moisture has become evenly distributed throughout the pieces than when first cooled. A rough test for moisture in dried fruits is to take up a double handful, squeeze it tight into a ball, and release the pressure. If the fruit seems soft, mushy, or wet, and sticks together when the pressure is released, the moisture content is probably 25 per cent. or more. If the fruit is springy, and, when the pressure is released, separates in a few seconds to form pieces of approximately the original size and shape, the moisture content is usually about 20 to 25 per cent. If the fruit feels hard or horny and does not press together, falling apart promptly when the pressure is released, the moisture content is probably below 20 per cent. At the proper stage of dryness vegetables look thoroughly dry and are often hard or crisp. The Association of Official Agricultural Chemists has published a method for the determination of moisture in dried fruits. In using methods of this type, care must be taken to select a composite sample from different parts of the lot, so that it will be representative of the lot as a whole, and directions for preparing the sample must be carefully followed in order to obtain dependable results. Products are never uniformly dry when removed from the drier. Large pieces and pieces not as directly exposed to the currents of heated air as most of the material contain more moisture than the rest. Products should be stored in large bins until the moisture becomes evenly distributed. This period of curing will usually take several weeks. An alternative method is to place the dried product in large friction‐top cans for curing, thus insuring complete protection from contamination and insect infestation. Leafy vegetables, like spinach, must remain in the drier until the moisture content of the stems is very low. At this point the product is bulky and the leaves are brittle. For economy in packing and handling it is desirable to reduce the bulk by compression. For this purpose the leaves are exposed to currents of cool damp air until they have reabsorbed just enough moisture to make them slightly flexible. For convenience in handling and to facilitate the application of heat or fumigation, products should be packed in the room where they were cured and stored. Such a room should be strictly clean, dry, cool and well ventilated. The doors should fit tightly, and the windows should be covered with fine‐mesh screen to exclude dust and insects. An abundance of light assists in detecting the presence of insects and in keeping the room clean. The types of containers chosen for packing will depend largely upon the severity of the storage conditions, with particular reference to the humidity and to chances of insect infestation. An ideal container would be one which, while moderate in cost, would keep the product from absorbing moisture when exposed to the most severe conditions of storage and shipment, and would be impervious to insects. Sealed tin cans and glass jars give absolute protection against moisture absorption and insect infestation. Friction‐top cans are nearly as good. Tin containers, necessary for export shipments of dehydrated foods, are more expensive than paper containers. Wooden boxes are generally used for bulk goods. Liners of heavy paper or cardboard, and sometimes additional liners of waxed paper, are used. The use of moisture‐proof cellophane packages is increasing. All types of paper containers with which experiments have been made allow the absorption of moisture when the products are stored in damp places. Also paper containers do not give perfect protection against all insects, some of which can bore holes in paper, while the larval forms of others are so small that they can crawl through the slightest imperfections at the joints where the cartons are sealed. Most products, however, keep satisfactorily in double or triple moisture‐proof cellophane or waxed‐paper bags packed in waxed, moisture‐proof cartons, provided the initial moisture content is low and no live insects in any form enter the package. Packing in insect‐proof and moisture‐proof packages cannot be too greatly stressed.

Examines the tenth published year of the ITCRR. Runs the whole gamut of textile innovation, research and testing, some of which investigates hitherto untouched aspects. Subjects discussed include cotton fabric processing, asbestos substitutes, textile adjuncts to cardiovascular surgery, wet textile processes, hand evaluation, nanotechnology, thermoplastic composites, robotic ironing, protective clothing (agricultural and industrial), ecological aspects of fibre properties – to name but a few! There would appear to be no limit to the future potential for textile applications.

Slough based Spectral Technology Ltd is the world's largest manufacturer of accelerated drying equipment, and along with its lamp manufacturing subsidiary Primarc Ltd has been involved in the development of UV and drying technology since the 1970's. The Group manufactures products employed for the drying and curing of inks and other surface coatings in the widest range of applications: from printing to wood finishing and printed circuit boards.