Table of contents
Formulation of local numerical methods in linear elasticity
Tiago Oliveira, Wilber Vélez, Artur PortelaThis paper is concerned with new formulations of local meshfree and finite element numerical methods, for the solution of two-dimensional problems in linear elasticity.
Performance assessment and optimization of hybrid composite patch repair of aircraft structure
Alpesh H. Makwana, A.A. ShaikhIn this article, a novel hybrid composite patch consisting of unidirectional carbon fiber and glass fiber is considered for repair of the aircraft structure. The purpose of this…
Theoretical and analytical analysis of convective heat transport of radiated micropolar fluid over a vertical plate under nonlinear Boussinesq approximation
Debarati Mahanty, Reeba Babu, B. MahantheshIn heat transfer problems, if the temperature difference is not sufficiently so small then the linear Boussinesq approximation is not adequate to describe thermal analysis. Also…
Optimization of process parameters on drilling of natural fibres reinforced in epoxy resin matrices using Taguchi–Grey relational analysis
Alagappan K M, Vijayaraghavan S, Jenarthanan M P, Giridharan RThe purpose of this paper is to identify the ideal process parameters to be set for the drilling of hybrid fibre-reinforced polymer (FRP) (kenaf and banana) composite using…
Numerical exploration of heat and mass transport for the flow of nanofluid subject to Hall and ion slip effects
Rahila Naz, Muhammad Sohail, T. HayatThis paper addresses the three-dimensional flow of viscous nanofluid bounded by two plates. The lower plate stretches while the upper plate remains stationary. The fluid is…
Optimal design of spherical roller bearings based on multiple tasking operating requirements
Rajiv Tiwari, Ashish JatThe fatigue, thermal and wear-based bearing lives are the most important factors in the design of spherical roller bearings (SRBs). The main novelty of the present work is…
MHD slip flow and convective heat transfer due to a moving plate with effects of variable viscosity and thermal conductivity
Mahantesh M. Nandeppanavar, M.C. Kemparaju, R. Madhusudhan, S. VaishaliThe steady two-dimensional laminar boundary layer flow, heat and mass transfer over a flat plate with convective surface heat flux was considered. The governing nonlinear partial…
Convective instability analysis of couple-stress dielectric fluid saturated anisotropic porous medium with radiation effect
Shruthy Myson, Smita Saklesh NagoudaThe effects of anisotropy and radiation cannot be considered negligible while investigating the stability of the fluid in convection. Hence, the purpose of this paper is to…
Computational study on MHD power-law fluid in tilted enclosure having sinusoidal heated sidewall
Minakshi PooniaIn the present computational study, the heat transfer and two-dimensional natural convection flow of non-Newtonian power-law fluid in a tilted rectangular enclosure is examined…
Analysis of radiative magneto nano pseudo-plastic material over three dimensional nonlinear stretched surface with passive control of mass flux and chemically responsive species
Muhammad Sohail, Rabeeah RazaThe current determination is committed to characterize the boundary layer flow of Williamson nanofluid prompted by nonlinear strained superficial under heat and mass transport…
Activation energy impact on radiated magneto-Sisko nanofluid flow over a stretching and slipping cylinder: entropy analysis
S. Sarkar, R.N. Jana, S. DasThe purpose of this article is to analyze the heat and mass transfer with entropy generation during magnetohydrodynamics (MHD) flow of non-Newtonian Sisko nanofluid over a…
Numerical simulation of Fisher's type equation via a collocation technique based on re-defined quintic B-splines
Neeraj Dhiman, Amit Chauhan, Mohammad Tamsir, Anand ChauhanA collocation technique based on re-defined quintic B-splines over Crank-Nicolson is presented to solve the Fisher's type equation. We take three cases of aforesaid equation. The…
The layout of Boussinesq couple-stress fluid flow over an exponentially stretching sheet with slip in porous space subject to a variable magnetic field
S. Das, R.R. Patra, R.N. JanaThe purpose of this study is to present the significance of Joule heating, viscous dissipation, magnetic field and slip condition on the boundary layer flow of an electrically…
Relating deformation parameters test research of mortar and limestone cooled to cryogenic temperatures
Zihao Shen, Yang Li, Kuizhou Liu, Jin Zhang, Yu SuThe coefficient of thermal expansion (CTE) and modulus of elasticity (ME) values of mortar and stone from room temperature to cryogenic temperatures provide an experimental basis…
Rayleigh–Bénard convection in a non-Newtonian dielectric fluid with Maxwell–Cattaneo law under the effect of internal heat generation/consumption
Keerthi R, B. Mahanthesh, Smita Saklesh NagoudaThe study of instability due to the effects of Maxwell–Cattaneo law and internal heat source/sink on Casson dielectric fluid horizontal layer is an open question. Therefore, in…
Optimization of WEDM process parameters in machining Nimonic 75 alloy using brass wire
Harvinder Singh, Vinod Kumar, Jathinder KapoorAn experimental study has been conducted to model and optimize wire electric discharge machining (WEDM) process parameters such as pulse-on time, pulse-off time, servo voltage and…
Parameter sensitivity analysis of stability of T-shaped rigid frame bridge by adopting swivel construction method
Jiawei Wang, Quansheng sunIn order not to affect the highway and railway traffic under the bridge during the construction process, bridges adopting swivel construction method are increasingly used at areas…
Introduction of new surface geometry to join Ti-6Al-4V and SS304L by friction welding
M. Balasubramanian, R. KumarIn friction welding of dissimilar joint method, few material compositions are not possible to weld effectively. For better dissimilar metal joining in friction welding, the…
Natural convection of Casson fluid in a square enclosure
Mohammad Saeid Aghighi, Christel Metivier, Hamed MasoumiThe purpose of this paper is to analyze the natural convection of a yield stress fluid in a square enclosure with differentially heated side walls. In particular, the Casson model…
Magnetic properties and hysteresis behavior of a ferrimagnetic mixed spin-3/2 and spin-5/2 Ising nanowire
Rachid Aharrouch, Karima El Kihel, Mohamed Madani, Nabil Hachem, Amer Lafhal, Mohammed El BouzianiThe purpose of this paper is to study the magnetic properties and the hysteresis behavior of a ferrimagnetic cubic Ising nanowire with mixed spins S = 3/2 and S = 5/2 in which the…
Magnetohydrodynamic flow of Carreau liquid over a stretchable sheet with a variable thickness: The biomedical applications
B. MahantheshThe magnetohydrodynamic (MHD) flow problems are important in the field of biomedical applications such as magnetic resonance imaging, inductive heat treatment of tumours…
Heat transport of nano-micropolar fluid with an exponential heat source on a convectively heated elongated plate using numerical computation
P.K. Pattnaik, S.R. Mishra, B. Mahanthesh, B.J. Gireesha, Mohammad Rahimi-GorjiThe study of novel exponential heat source phenomena across a flowing fluid with a suspension of microparticles and nanoparticles towards a convectively heated plate has been an…
ISSN:
1573-6105e-ISSN:
1573-6113ISSN-L:
1573-6105Online date, start – end:
2005Copyright Holder:
Emerald Publishing LimitedOpen Access:
hybridEditors:
- Dr Xiao-Ping Zhang
- Professor Zhufeng Yue
- Prof Heng Xiao