New range of non-contact rotary torque transducers

Citation

(2002), "New range of non-contact rotary torque transducers", Sensor Review, Vol. 22 No. 3. https://doi.org/10.1108/sr.2002.08722caf.003

New range of non-contact rotary torque transducers

New range of non-contact rotary torque transducers

Keyword: Torque

Sensor Technology has introduced their new range of Torqsense RWT rotary torque transducers.

With full-scale ranges between 100mNm and 10,000Nm, the E300 RWT1 series of transducers utilizes the little known surface acoustic wave (SAW) phenomenon. This SAW approach has allowed the development of small transducers, which are not only exceptionally accurate, but more importantly, require no physical contact between the revolving shaft and its housing (Plate 3).

In a Torqsense transducer, the surface waves are produced by passing an alternating voltage across the terminals of two interleaved comb-shaped arrays that are laid onto one end of the piezoelectric substrate. A similar "receiving" array, at the other end of the substrate, converts the wave back into an electric signal.

The frequency of the wave generated is dependent on the spacing of the "teeth" in the comb array and as the direction of the wave propagation is at right angles to the teeth, any change in its length alters the spacing of the teeth and the operating frequency.

Plate 3 A portable PC, a sensor technology Torqsense torque transducer and an E-series instrument

To measure torque in a shaft, two SAW sensors are bonded rigidly to a shaft at 45 degrees to the axis and connected in a "half bridge" configuration, so that when the shaft is subjected to a torque, outputs are combined to produce a "difference" signal proportional to applied torque. This signal is exchanged via a capacitive rotor and stator.

Torqsense transducers require minimum length of shaft, have low inertia, no physical contact between shaft and housing, wide bandwidth, high resolution and accuracy, and excellent noise immunity. The technology lends itself to design of OEM transducers for specific customer applications.

The transducers are available with RPM output and IP65 sealing as options, and interface with the E302 advanced torque transducer display, which features full temperature correction for changes in the modulus of elasticity of the shaft. The E302 can be interfaced with Torqview Virtual Instrumentation Display PC software to give a self-contained data display and recording system.

Applications include automotive, aerospace, viscosity and consistency measurement, motor and machinery control and condition monitoring, and torque control of tightening procedures.

For further information contact: Sensor Technology Ltd, PO Box 36, Banbury, Oxon 0X15 6JB, UK. Tel: +44 (0)1295 730746; Fax: +44 (0)1295 738968; E-mail: info@sensors.co.uk; Web site: http://www.sensors.co.uk