Dry sliding of composites with PBT matrix and micro glass beads on steel

Abstract

Purpose

This research aims to characterize the tribological behavior of polybutylene terephthalate (PBT) and PBT composites with micro glass beads (MGB) on steel, in dry conditions and on a block-on-ring tester, pointing out the influence of sliding distance and speed. The tribology of PBT and its composites is still in an early stage because this thermoplastic polyester requires accurate technological and thermal treatment.

Design/methodology/approach

The composites were produced by ICEFS Savinesti Romania and contain PBT grade Crastin6130NC010 (as supplied by Du Pont), 0.5 […] 1.0 per cent (weight) Relamyd B-2Nf (polyamide grade produced by ICEFS, for a better dispersion of MGB), 1 per cent (weight) black carbon for technological and tribological reasons and different micro glass beads (MGB) concentrations (10.0 and 20.0 per cent weight). Tests were done for different sliding distances (2,500, 5,000 and 7,500 m) and speeds (0.5, 1.0 and 1.5 m/s) and a normal load of 5 N.

Findings

The friction coefficient and the wear parameter (as mass loss of polymeric blocks) pointed out a good tribological behavior for these composites. Scanning electron microscope (SEM) images revealed particular aspects of PBT local transfer on steel. Also, 10 per cent MGB in PBT reduces wear, especially for longer distances (75,000 m) and higher speeds (0.5 and 0.75 m/s); the friction coefficient is only slightly increased up to 0.23, being less influenced by the speed and the sliding distance as compared to neat polymer.

Originality/value

PBT and PBT composites could become challengers for replacing materials in applications similar to tested ones. Even the neat polymer exhibits a good tribological behavior. The composites have a lower sensibility to higher speeds and sliding distances for the applied load.

Citation

Georgescu, C., Deleanu, L. and Botan, M. (2014), "Dry sliding of composites with PBT matrix and micro glass beads on steel", Industrial Lubrication and Tribology, Vol. 66 No. 3, pp. 424-433. https://doi.org/10.1108/ilt-03-2012-0026