Bossed diaphragm coupled fixed guided beam structure for MEMS based piezoresistive pressure sensor

Abstract

Purpose

Structures play a very important role in developing pressure sensors with good sensitivity and linearity, as they undergo deformation to the input pressure and function as the primary sensing element of the sensor. To achieve high sensitivity, thinner diaphragms are required; however, excessively thin diaphragms may induce large deflection and instability, leading to the unfavorable performances of a sensor in terms of linearity and repeatability. Thereby, importance is given to the development of innovative structures that offer good linearity and sensitivity. This paper aims to investigate the sensitivity of a bossed diaphragm coupled fixed guided beam three-dimensional (3D) structure for pressure sensor applications.

Design/methodology/approach

The proposed sensor comprises of mainly two sensing elements: the first being the 3D mechanical structure made of bulk silicon consisting of boss square diaphragm along with a fixed guided beam landing on to its center, forming the primary sensing element, and the diffused piezoresistors, which form the secondary sensing element, are embedded in the tensile and compression regions of the fixed guided beam. This micro mechanical 3 D structure is packaged for applying input pressure to the bottom of boss diaphragm. The sensor without pressure load has no deflection of the diaphragm; hence, no strain is observed on the fixed guided beam and also there is no change in the output voltage. When an input pressure P is applied through the pressure port, there is a deformation in the diaphragm causing a deflection, which displaces the mass and the fixed guided beam vertically, causing strain on the fixed guided beam, with tensile strain toward the guided end and compressive strain toward the fixed end of the close magnitudes. The geometrical dimensions of the structure, such as the diaphragm, boss and fixed guided beam, are optimized for linearity and maximum strain for an applied input pressure range of 0 to 10 bar. The structure is also analyzed analytically, numerically and experimentally, and the results are compared.

Findings

The structure offers equal magnitudes of tensile and compressive stresses on the surface of the fixed guided beam. It also offers good linearity and sensitivity. The analytical, simulation and experimental studies of this sensor are introduced and the results correlate with each other. Customized process steps are followed wherein two silicon-on-insulator (SOI) wafers are fusion bonded together, with SOI-1 wafer used to realize the diaphragm along with the boss and SOI-2 wafer to realize the fixed guided beam, leading to formation of a 3D structure. The geometrical dimensions of the structure, such as the diaphragm, boss and fixed guided beam, are optimized for linearity and maximum strain for an applied input pressure range of 0 to10 bar.

Originality/value

This paper presents a unique and compact 3D micro-mechanical structure pressure sensor with a rigid center square diaphragm (boss diaphragm) and a fixed guided beam landing at its center, with diffused piezoresistors embedded in the tensile and compression regions of the fixed guided beam. A total of six masks were involved to realize and fabricate the 3D structure and the sensor, which is presumed to be the first of its kind in the fabrication of MEMS-based piezoresistive pressure sensor.

Citation

Manuvinakurake, M., Gandhi, U., Umapathy, M. and Nayak, M.M. (2019), "Bossed diaphragm coupled fixed guided beam structure for MEMS based piezoresistive pressure sensor", Sensor Review, Vol. 39 No. 4, pp. 586-597. https://doi.org/10.1108/SR-10-2018-0275