An active compliant docking method for large gear components based on distributed force sensor

Abstract

Purpose

Large gear components widely exist in the transmission system of helicopters, ships, etc. Due to the small assembly clearance of large gear components, using an automatic docking system based on position control will lead to forced assembly. The purpose of this paper is to reduce the assembly stress of large gear components by an active compliant docking technology based on distributed force sensors.

Design/methodology/approach

Firstly, aiming at the noise interference in three-dimensional force sensor (TDFS), Kalman filter and Savitzky–Golay filter are used to process the sensor’s output signal. Secondly, the active compliant docking control model is constructed according to the principle of impedance control. Thirdly, the contact force is calculated based on the Euler equation, and the impedance control parameters are tuned by the particle swarm optimization algorithm. Finally, an active compliant docking system of a large gear structure based on distributed force sensor is built in the laboratory to verify the proposed method.

Findings

The experimental results show that the contact force and contact torque gradually decrease in all directions and are always in the safe range during the docking process. The feasibility of this method in practical application is preliminarily demonstrated.

Originality/value

The distributed TDFSs are used to replace the traditional six-dimensional force sensor in the active compliant docking system of gear components, which solves the problem of the small bearing capacity of the conventional active compliant docking system. This method can also be used for the docking of other large components.

Citation

Chu, W. and Huang, X. (2022), "An active compliant docking method for large gear components based on distributed force sensor", Sensor Review, Vol. 42 No. 3, pp. 303-315. https://doi.org/10.1108/SR-08-2021-0262