To read this content please select one of the options below:

A new combined transient extraction method coupled with WO3 gas sensors for polluting gases classification

Rabeb Faleh (College of Computer and Information Sciences, Jouf University, Sakaka, Saudi Arabia)
Sami Gomri (Ecole Nationale d'Ingenieurs de Sfax, Sfax, Tunisia)
Khalifa Aguir (Institut des Materiaux de Microelectronique et des Nanosciences de Provence, Aix-Marseille Université, Aix-en-Provence, France)
Abdennaceur Kachouri (National School of Engineers of Sfax, Sfax, Tunisia)

Sensor Review

ISSN: 0260-2288

Article publication date: 1 October 2021

Issue publication date: 14 October 2021

137

Abstract

Purpose

The purpose of this paper is to deal with the classification improvement of pollutant using WO3 gases sensors. To evaluate the discrimination capacity, some experiments were achieved using three gases: ozone, ethanol, acetone and a mixture of ozone and ethanol via four WO3 sensors.

Design/methodology/approach

To improve the classification accuracy and enhance selectivity, some combined features that were configured through the principal component analysis were used. First, evaluate the discrimination capacity; some experiments were performed using three gases: ozone, ethanol, acetone and a mixture of ozone and ethanol, via four WO3 sensors. To this end, three features that are derivate, integral and the time corresponding to the peak derivate have been extracted from each transient sensor response according to four WO3 gas sensors used. Then these extracted parameters were used in a combined array.

Findings

The results show that the proposed feature extraction method could extract robust information. The Extreme Learning Machine (ELM) was used to identify the studied gases. In addition, ELM was compared with the Support Vector Machine (SVM). The experimental results prove the superiority of the combined features method in our E-nose application, as this method achieves the highest classification rate of 90% using the ELM and 93.03% using the SVM based on Radial Basis Kernel Function SVM-RBF.

Originality/value

Combined features have been configured from transient response to improve the classification accuracy. The achieved results show that the proposed feature extraction method could extract robust information. The ELM and SVM were used to identify the studied gases.

Keywords

Citation

Faleh, R., Gomri, S., Aguir, K. and Kachouri, A. (2021), "A new combined transient extraction method coupled with WO3 gas sensors for polluting gases classification", Sensor Review, Vol. 41 No. 5, pp. 437-448. https://doi.org/10.1108/SR-02-2021-0066

Publisher

:

Emerald Publishing Limited

Copyright © 2021, Emerald Publishing Limited

Related articles