Multiaxis wire and arc additive manufacturing for overhangs based on conical substrates

Abstract

Purpose

This paper aims to present a series of approaches for three-related issues in multiaxis in wire and arc additive manufacturing (WAAM) as follows: how to achieve a stable and robust deposition process and maintain uniform growth of the part; how to maintain consistent formation of a melt pool on the surface of the workpiece; and how to fabricate an overhanging structure without supports.

Design/methodology/approach

The principal component analysis-based path planning approach is proposed to compute the best scanning directions of slicing contours for the generation of filling paths, including zigzag paths and parallel skeleton paths. These printing paths have been experimented with in WAAM. To maintain consistent formation of a melt pool at overhanging regions, the authors introduce definitions for the overhanging point, overhanging distance and overhanging vector, with which the authors can compute and optimize the multiaxis motion. A novel fabricating strategy of depositing the overhanging segments as a support for the deposition of filling paths is presented.

Findings

The second principal component of a planar contour is a reasonable scanning direction to generate zigzag filling paths and parallel skeleton filling paths. The overhanging regions of a printing layer can be supported by pre-deposition of overhanging segments. Large overhangs can be successfully fabricated by the multiaxis WAAM process without supporting structures.

Originality/value

An intelligent approach of generating zigzag printing paths and parallel skeleton printing paths. Optimizations of depositing zigzag paths and parallel skeleton paths. Applications of overhanging point overhanging distance and overhanging vector for multiaxis motion planning. A novel fabricating strategy of depositing the overhanging segments as a support for the deposition of filling paths.

Citation

Dai, F., Zhang, S., Li, R. and Zhang, H. (2022), "Multiaxis wire and arc additive manufacturing for overhangs based on conical substrates", Rapid Prototyping Journal, Vol. 28 No. 1, pp. 126-142. https://doi.org/10.1108/RPJ-12-2020-0300