Mechanical and surface characterisation of additively manufactured polyetheretherketone for the tribo test

Abstract

Purpose

The additive manufacturing process, such as fused filament fabrication based on material extrusion, fabricates the samples layer-by-layer. The various parameters in the process significantly affect the dimensions, structure and mechanical properties of the fabricated parts. The purpose of this paper is to investigate the surface and mechanical properties that can affect the contact characteristics with other materials during tribological tests.

Design/methodology/approach

The investigation of 3D-printed Polyetheretherketone (PEEK) includes the measurement of dimensions, microhardness, surface roughness, surface energy and tensile strength to define material characteristics. The crystallinity is measured using an X-ray diffractometer to understand the hardness behaviour.

Findings

The printing parameters affect its surface roughness, hardness and crystallinity. This change in parameters such as layer thickness and infill density impacts mechanical properties such as hardness and surface roughness, which will influence the contact mechanism with the counter body during any tribological test. The change in a single parameter during the sample fabrication and the change in the surface and mechanical properties are observed.

Research limitations/implications

The material cost plays an important role in conducting numerous destructive tests, which is a major limitation to conducting parameter optimisation by varying more parameters. The study is limited to the as-fabricated samples rather than finished samples and without any heat treatment. Achieving optimal parameters is integral to the success of additive manufacturing, ensuring the production of components with consistent performance.

Practical implications

The study aims at the application of 3D-printed PEEK for bush or journal bearings that can be directly used in practice. The mechanical properties discussed in this paper can fill the gap between theory and practice.

Social implications

The research provides all fundamental properties, including the printing parameters and their effect on the dimensions and surface structure, which are required to understand the material and its use. The results are consistent as at least four samples were tested for tribological behaviour. The conclusion is updated as per suggestions.

Originality/value

The study outlines the relationship between the change in layer thickness and infill density with changes in surface energy, surface roughness, hardness and tensile strength. The deformation and adhesion during the friction test depend on these properties.

Citation

Prajapati, S.K. and R., G. (2024), "Mechanical and surface characterisation of additively manufactured polyetheretherketone for the tribo test", Rapid Prototyping Journal, Vol. ahead-of-print No. ahead-of-print. https://doi.org/10.1108/RPJ-05-2024-0188