Investigation of formation, microstructure and hardness of Ti-6Al-4V single tracks via Joule-fused filament additive manufacturing

Abstract

Purpose

This paper aims to investigate a novel additive manufacturing (AM) method for titanium alloy using Joule heat as the single heat source to melt TC4 wire, which intends to provide a new low-power, low-cost solution for the processing of titanium alloys.

Design/methodology/approach

When current flows through the wire and the substrate, Joule heat will be generated to melt the wire and join the wire with the substrate. By stacking the wire layer by layer, finally a part can be formed. The cross-sectional morphology, microstructure and hardness of TC4 single track deposits formed by Joule heat melting wire AM were investigated by various characterization methods.

Findings

The melting width and melting penetration decreased with the increase of printing speeds. There is no obvious change in single track morphology with the change of printing pressures. The melting width and melting penetration increased with the increase of printing currents. The observation of the internal microstructure of a single track reveals a decrease in grain size as printing speeds increase. The average hardness of the single track was about 363 HV, which is comparable to the hardness of the parts fabricated by selective laser melting process. The printing power is less than 300 W, which is lower than other AM processes.

Originality/value

This paper provides a novel solution for the processing of titanium alloy parts. Compared with other expensive energy sources, this work only uses an ordinary DC power supply as the energy source. The printing process is simple and the cost is low. The power is much lower than other AM processes.

Citation

Jiawen, L., Li, B., Li, Z., Chen, Y., Liu, J. and Lu, B. (2024), "Investigation of formation, microstructure and hardness of Ti-6Al-4V single tracks via Joule-fused filament additive manufacturing", Rapid Prototyping Journal, Vol. ahead-of-print No. ahead-of-print. https://doi.org/10.1108/RPJ-04-2024-0181