In situ flaw detection by IR‐imaging during electron beam melting

Abstract

Purpose

The purpose of this paper is to investigate the possibility of in situ flaw detection for powder bed, beam‐based additive manufacturing processes using a thermal imaging system.

Design/methodology/approach

The authors compare infrared images (IR) which were taken during the generation of Ti‐6Al‐4V parts in a selective electron beam melting system (SEBM) with metallographic images taken from destructive material investigation.

Findings

A good match is found between the IR images and the material flaws detected by metallographic techniques.

Research limitations/implications

First results are presented here, mechanisms of flaw formation and transfer between build layers are not addressed in detail.

Originality/value

This work has important implications for quality assurance in SEBM and rapid manufacturing in general.

Citation

Schwerdtfeger, J., Singer, R.F. and Körner, C. (2012), "In situ flaw detection by IR‐imaging during electron beam melting", Rapid Prototyping Journal, Vol. 18 No. 4, pp. 259-263. https://doi.org/10.1108/13552541211231572