Optimal burn‐in time for general repairable products sold under failure‐free renewing warranty

Abstract

Purpose

To investigate the optimal burn‐in time from the perspective of minimizing the expected total cost (i.e. manufacturing plus warranty costs) per unit of product sold under a failure‐free renewing warranty policy. The conditions indicating when burn‐in becomes beneficial were also derived.

Design/methodology/approach

An age‐dependent general repairable product sold under a failure‐free renewing warranty agreement was considered. In the case of such a general repairable model, there are two ways in which the product can fail: type I failure (minor) can be rectified through minimal repairs; while in type II failure (catastrophic), the product must be replaced. Then optimal burn‐in time is then examined in order to achieve a trade‐off between reducing the warranty cost and increasing the manufacturing cost.

Findings

The optimal burn‐in time depends on the failure/repair characteristics, length of warranty, cost parameters and the probability of failure type II (catastrophic). A burn‐in program is beneficial if the initial failure rate is high or product failures during the warranty period are costly. Moreover, the optimal burn‐in time is always less than the infant mortality period.

Originality/value

The product considered in this paper is an age‐dependent general repairable product: on which no such study has yet been conducted. This is also the first study to apply a failure‐free renewing warranty to a general repairable item. It can be seen that the present model is a generalization of the model considered by Chien and Sheu.

Citation

Chien, Y. (2005), "Optimal burn‐in time for general repairable products sold under failure‐free renewing warranty", International Journal of Quality & Reliability Management, Vol. 22 No. 7, pp. 651-666. https://doi.org/10.1108/02656710510610811