To read this content please select one of the options below:

Hybrid corrosion‐resistant coatings analyzed using electrochemical noise

Fernando García‐Hernandez (Universidad Autonoma de Queretaro, Santiago de Queretaro, Mexico)
Luis Hernández‐Sandoval (Universidad Autonoma de Queretaro, Santiago de Queretaro, Mexico)
Carlos Regalado‐González (Universidad Autonoma de Queretaro, Santiago de Queretaro, Mexico)
José Mojica‐Gómez (Parque Technologico Queretaro Sanfandila, Pedro Escobedo, Mexico)
Yunny Meas‐Vong (Parque Technologico Queretaro Sanfandila, Pedro Escobedo, Mexico)
Guillermo Espinosa‐Acosta (Universidad Nacional Autonoma de Mexico (UNAM), Santiago de Queretaro, Mexico)
Miriam Estévez (Universidad Nacional Autonoma de Mexico (UNAM), Santiago de Queretaro, Mexico)
Victor Castaño (Universidad Nacional Autonoma de Mexico (UNAM), Santiago de Queretaro, Mexico)

Anti-Corrosion Methods and Materials

ISSN: 0003-5599

Article publication date: 6 November 2009

480

Abstract

Purpose

The purpose of this paper is to study the corrosion of carbon steel without coating and when protected using three different hybrid coatings, i.e. a bi‐component polyurethane with nano‐particles of SiO2 with and without sacrificial anode particles, and a mono‐component polyurethane with SiO2 particles.

Design/methodology/approach

In this investigation three different nano‐structured coatings are developed and applied to steel substrates and then tested for their corrosion resistance (defined as “Rn”), under a very aggressive medium (pH=1.5) in a dynamic system (loop reactor). Their performance is evaluated using an electrochemical noise (EN) resistance technique. The electrodes are connected to a potentiostat and measurements are recorded as per the EN technique over a 2,048 s duration at 0, 24, and 48 h intervals. Scanning electron microscopy (SEM) are obtained before and after the corrosion trials to characterize the control and the different coating systems.

Findings

The results show that a bicomponent coating, made up of alkyd resin and silica nanoparticles demonstrated the best performance, whereas the coating formed by SiO2 nanoparticles and polyurethane resin showed relatively low corrosion resistance. The inclusion of zinc nanoparticles in a third coating as sacrificial nano‐anodes led to segregation and resulted in moderate corrosion resistance. These results are confirmed by SEM observations.

Originality/value

The results obtained in this paper provide an insight to the understanding of the anticorrosion properties of three different hybrid coatings in a dynamic system (loop reactor).

Keywords

Citation

García‐Hernandez, F., Hernández‐Sandoval, L., Regalado‐González, C., Mojica‐Gómez, J., Meas‐Vong, Y., Espinosa‐Acosta, G., Estévez, M. and Castaño, V. (2009), "Hybrid corrosion‐resistant coatings analyzed using electrochemical noise", Anti-Corrosion Methods and Materials, Vol. 56 No. 6, pp. 310-315. https://doi.org/10.1108/00035590911000287

Publisher

:

Emerald Group Publishing Limited

Copyright © 2009, Emerald Group Publishing Limited

Related articles